<*********>青石破碎机_大型青石锤破机_青石破碎机厂家

青石是各种石材中环保的石材，因取材方便，具有耐磨、耐风化、无辐射等特点，破碎后广泛用于建筑行业中。青石破碎生产线每小时可生产*********吨物料。青石破碎生产线设备有：给料设备、破碎设备、筛分设备、输送设备、制砂设备、洗砂设备、除尘设备组成。

青石破碎机是青石破碎生产线的设备之一。主要作用是：将从山上开采的大块青石料进行破碎，破碎至*********以下成品料，破碎+整形，二合一设备。

青石破碎机工作原理：电动机经三角带、大带轮带动转子高速旋转；待破碎物料由喂料设备经入料口送入破碎腔、高速旋转的转子带动锤头对物料进行次打击；获得动能后的物料高速撞向反击板得到二次破碎；碰撞反弹后或遭锤头再次打击或与其它物料相互碰撞。物料在碰撞的过程中逐渐向破碎腔下部的活动反击板移动，当物料粒度小于锤头与活动反击板之间的间隙时，在自重和其它物料的压挤下脱离破碎腔,从而结束一个完整的破碎过程。排出后的物料由筛选设备筛选后,部分大于选用标准的物料,需运送破碎机进行二次破碎。

青石碎石机是青石制砂生产线中的设备。主要用于：将破碎设备处理后的半成品料进行加工处理，获得用于盖房的大沙。

青石碎石机工作原理：青石碎石机主要由机体、破碎板、上转子、下转子、摆锤、旋转驱动装置、筛板等组成，该机在工作过程中两个转子相对运转，进入破碎腔的物料由个转子上的锤头进行打击破碎并获得的动能后撞向第二个转子，由于第二个转子与物料飞来的方向相反，此时第二个转子对物料的打击速度等于两个速度的叠加，物料经如此多次的循环打击而破碎后经篦条的缝隙排出。破碎原料(石灰岩、青石、砾石、煤矸石、煤、片麻岩等)通过ZG振动给料机均匀地喂入PCZ重型锤式破碎机初步破碎，经粗碎后的成品通过皮带输送机输送至PC锤式破碎机破进一步破碎，二次破碎后的石料通过皮带输送机输送至青石破碎机再次破碎，再次破碎整形处理的石料通过皮带输送机输送至YK振动筛筛分出不同规格的石子，满足客户粒度要求的石子通过皮带输送机输送至成品料堆，不合格的石子通过皮带输送机重新返回至青石破碎机再次破碎，形成闭路多次循环完成。

********* is an ********* ********* stone among ********* types of *********. Due to its ********* ********* *********, it has the ********* of wear *********, ********* *********, and non *********. After *********, it is ********* used in the ********* *********. The ********* ********* ********* line can ********* ********* tons of ********* per hour. The ********* for the ********* ********* ********* line ********* of ********* *********, ********* *********, ********* *********, ********* *********, sand ********* *********, sand ********* *********, and dust ********* *********.

The ********* ********* is one of the ********* in the ********* ********* ********* line. The main ********* is to crush large ********* of green stone ********* from the *********, ********* them to ********* ********* below *********, and using a two in one ********* for ********* and *********.

********* ********* of ********* *********: The motor ********* the rotor to ********* at high speed ********* a ********* and a large *********; The ********* to be ********* is fed into the ********* ********* ********* the ********* port by the ********* *********, and the ********* ********* rotor ********* the ********* to ********* the *********; After ********* ********* *********, the ********* ********* with the ********* plate at high speed and ********* ********* *********; After ********* and *********, or being hit again by a ********* or ********* with other *********. ********* the ********* *********, the ********* ********* moves ********* the ********* ********* plate at the ********* of the ********* *********. When the ********* size of the ********* is ********* than the gap ********* the ********* head and the ********* ********* plate, it ********* from the ********* ********* under its own ********* and the ********* of other *********, thus ********* a ********* ********* *********. After the ********* ********* are ********* by the ********* *********, some of the ********* that are ********* than the ********* ********* need to be ********* to the ********* for ********* *********.

The ********* ********* is an ********* in the ********* sand ********* line. ********* used for ********* ********* ********* ********* by ********* ********* to ********* large sand for *********.

********* ********* of ********* *********: The ********* ********* is ********* ********* of a body, a ********* plate, an upper rotor, a lower rotor, a *********, a ********* drive *********, a sieve plate, etc. ********* the ********* of the *********, the two ********* ********* ********* to each other. The ********* ********* the ********* ********* is ********* by the ********* head on each rotor and the ********* ********* ********* is then ********* with the ********* rotor. Since the ********* of the ********* rotor is ********* to the ********* of the ********* *********, the ********* speed of the ********* rotor on the ********* is equal to the ********* of the two *********. After so many ********* of *********, the ********* is ********* and ********* ********* the gap of the grate. ********* raw ********* (*********, *********, *********, coal *********, coal, *********, etc.) are ********* fed into the PCZ ********* ********* ********* ********* a ZG ********* ********* for ********* *********. The ********* ********* ********* ********* is ********* to the PC ********* ********* for ********* ********* ********* a belt *********. The stone ********* after ********* ********* is ********* to the ********* ********* for ********* ********* ********* a belt *********. The stone ********* after ********* ********* and ********* is ********* to the YK ********* ********* for ********* ********* ********* of ********* ********* a belt *********. The ********* that meet the *********'s ********* size ********* are ********* to the ********* ********* pile ********* a belt *********, and the ********* ********* are ********* to the ********* ********* for ********* ********* ********* a belt *********, ********* a ********* ********* for ********* ********* to *********.